How to get started using your Basic Package...
1. The graphite cloth pictured here is the EnviroCloth, wet this one. The purple cloth it is the WindowCloth, used dry.
2. Cleaning with the EnviroCloth. Fold the cloth in half, then turn and fold in half again. Holding flat in your hand to come into full contact with the surfaces you are cleaning. This ensures you will pick up 99% of the bacterial contaminant from the surfaces, mechanically cleaning not chemically cleaning.
 |
| Folded EnviroCloth |
3. Wipe your cleanest surfaces in the area you are cleaning, whether it is your bedroom, the kitchen, or the bathroom. As you continue to clean you will need to use a fresh side, simply flip the first time, then inverting the first fold and using those two sides. That will be four sides used. to move to the next four sides unfold the cloth, refold with the unused sides to the outside refold.
4. Rinse your cloth as needed throughout the cleaning process, shaking off crumbs etc...into the sink or trash. Rub the cloth against itself under hot running water. If it has become greasy cleaning in the kitchen add a little Norwex Dish Soap to the cleaning process, rinsing well.
5. Some surfaces you are cleaning removing grime....well, they need to shine! Mirrors, windows, stainless steel, faucets.....For this you will use the WindowCloth. While the surface is still damp from the EnviroCloth use the folded WindowCloth to dry and polish! It's a Sparkling, Streak-Free, and Stunning result every time!
6. Finish up by rinsing out the EnviroCloth in hot water, fold one time and roll the fold cloth, twisting it until it isn't dripping. The WindowCloth does not require rinsing as it is normally only damp, not dirty from polishing clean surfaces. Now hang each by their name tag from a hook on your island, the back of the laundry room door, or any non humid area to dry. Remember this is when the micro-silver sanitizes the clothes. The silver is present in all cloths that say "BacLock", which is a excellent reminder to hang them!
 |
| Household Package. |
 |
1. Place the Dusting Mitt on your hand, use "No" sprays of any kind!
2. Pick up items and dust them, dust the surface where they were sitting, replace the item. Done! If you have a mitt for each hand even better!
3. To clean simply take it outside for a good shake or better yet grab the Norwex Rubber Brush and remove the dust while you recharge the fibers for another round of dusting!
2. Pick up items and dust them, dust the surface where they were sitting, replace the item. Done! If you have a mitt for each hand even better!
3. To clean simply take it outside for a good shake or better yet grab the Norwex Rubber Brush and remove the dust while you recharge the fibers for another round of dusting!
No comments:
Post a Comment
All comments will be reviewed for content inappropriate language before being published.